Automated Tape Laying Gallery
Automated Tape Laying Gallery
I would like to know / Understand what is the Compression moulded graphite.
Fri, 07/08/2011 - 6:05am — Som (not verified)
Not answered yet.
Can you make a 9" I.D. CF tube of about 2" length (much then like a hoop or ring)?
Tue, 06/28/2011 - 3:05pm — Dr. Mike Moore (not verified)
Not answered yet.
What are the requirements/properties (values) needed for pipes in deep-sea environment?
Wed, 06/15/2011 - 8:25am — Jenny Arbon (not verified)
Not answered yet.
What speed can you to obtain in tape laying?
Wed, 12/22/2010 - 6:59am — Antonio Jonny (not verified)
Not answered yet.
Design of shaft in propeller of old helicopter and material ?
Thu, 12/16/2010 - 4:21pm — mohammed adel (not verified)
Not answered yet.
what range of the parameters that your ATL could reach
Wed, 11/17/2010 - 8:20am — Gangtang Luo (not verified)
Not answered yet.
I had a couple of questions about thermoplastics for a report I am working on
Mon, 11/01/2010 - 10:13pm — Ben Woods (not verified)
Not answered yet.
